Steinberg UR28M Operation Manual page 19

Usb audio interface
Hide thumbs Also See for UR28M:
Table of Contents

Advertisement

Panel Controls
Input Settings Window
+48V
Indicates the on/off status of the phantom power
function of the device.
Phase
Turns on (lit) and off (dark) the phase inversion of
the signal.
High Pass Filter
Turns on (lit) and off (dark) the high pass filter.
To select the cutoff frequency of the high pass
filter, use the "Settings Window" (page 21) in the
section "Dedicated Windows for Cubase Series."
Effect Edit
Opens the selected effect setup window.
Effect Type
Selects the effect.The maximum number of
Channel Strip and Guitar Amp Classics iterations
which can be used simultaneously has
restrictions. Refer to the "Limitations on the use of
effects" (page 36).
DRIVE / Output Level
When Channel Strip is selected, this adjusts the
degree to which the compressor is applied. The
higher the value, the greater the effect.
Range: 0.00 – 10.00
When Guitar Amp Classics is selected, this
adjusts the output level.
Range: 0.00 - 1.00
Panel Controls for the Software Programs
MORPH
Adjusts the Channel Strip Sweet Spot Data.
(Refer to the "MORPH" in the section "Channel
Strip" on page 22.)
When Guitar Amp Classics is selected, MORPH is
not displayed.
Effect Insertion Location
Selects the insertion location of an effect.
Insertion
Description
location
Upper
Turns the effect off.
(OFF)
Middle
Applies an effect Strip to only the
(MON.FX)
monitor signal (sent to the device).
Lower
Applies an effect Strip to both the
(INS.FX)
monitor signal (sent to the device)
and the recording signal (sent to the
DAW software).
Output Position of the Direct Monitoring
Signal
Indicates the position from which the audio
signals for monitoring will be output when turning
on Direct Monitoring in the device settings on
Cubase.
REV-X Edit
Opens the "REV-X" (page 24) setup window.
REV-X Send
Adjusts the signal level which is sent to the
REV-X.
Range: -∞ dB – +6.00 dB
Headphones Edit
Opens the "Headphones Window" (page 20) in
the section "Dedicated Windows for Cubase
Series."
Reverb Routing Edit
Opens the "Reverb Routing Window" (page 20) in
the section "Dedicated Windows for Cubase
Series."
UR28M
Operation Manual
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents