Steinberg UR28M Operation Manual page 25

Diffusion
Adjusts the spread of the reverberation.
Range: 0 – 10
HPF
Adjusts the cutoff frequency of the high pass filter.
Range: 20 Hz – 8.0 kHz
LPF
Adjusts the cutoff frequency of the low pass filter.
Range: 1.0 kHz – 20.0 kHz
Hi Ratio
Adjusts the duration of reverberation in the high
frequency range by using a ratio relative to the
Reverb Time. When you set this parameter to 1,
the actual specified Reverb Time is fully applied
to the sound. The lower the value, the shorter the
duration of reverberation in the high frequency
range.
Range: 0.1 – 1.0
Low Ratio
Adjusts the duration of reverberation in the low
frequency range by using a ratio relative to the
Reverb Time. When you set this parameter to 1,
the actual specified Reverb Time is fully applied
to the sound. The lower the value, the shorter the
duration of reverberation in the low frequency
range.
Range: 0.1 – 1.4
Low Freq
Adjusts the frequency of the Low Ratio.
Range: 22.0 Hz – 18.0 kHz
OPEN/CLOSE
Opens and closes the window which adjusts the
reverb settings.
Graph
Indicates the characteristics of reverberation. The
vertical axis indicates the signal level, the
horizontal axis indicates the time, and the Z-axis
indicates the frequency. You can adjust the
characteristics of reverberation by dragging the
handles in the graph.
OUTPUT (VST Plug-in version only)
Indicates the output level of the REV-X.
MIX (VST Plug-in version only)
Adjusts the output level balance between the
original sound and effect sound.
Range: 0% – 100%
Panel Controls for the Software Programs
Time Axis Setting
Select the display range of the time (horizontal
axis) on the graph.
Display range: 500 msec – 50 sec
Zoom Out
Zooms out the display range of the time
(horizontal axis) on the graph.
Zoom In
Zooms in the display range of the time (horizontal
axis) on the graph.
TIPS
•You can reset some parameters to the default
value by holding the [Ctrl]/[command] key while
you click on the knobs, sliders, and faders.
•You can adjust the parameters more finely by
holding the [SHIFT] key while you drag on the
knobs, sliders, and faders.
Operation Manual
UR28M
25