Steinberg UR28M Operation Manual page 9

MIX 1–3 lamp
For Alternate mode, this indicates the output
signal (MIX 1–3) of the LINE OUTPUT.
For Independent mode, this indicates the output
signal (MIX 1–3) of the LINE OUTPUT selected by
OUTPUT buttons A–C.
For details on the mode, including how to select
the mode, refer to the "Setup Window" (page 16)
in the section "dspMixFx UR28M" or the "Master
Levels Window" (page 21) in the section
"Dedicated Windows for Cubase Series."
DIM button
Turns on (lit) and off (dark) the dimmer of all LINE
OUTPUT signals.
When you turn on this button, the output signal
level of all LINE OUTPUT will be attenuated by 20
dB. Turning on and off this button will not affect
the output signal level of PHONES 1/2.
MONO MIX button
For Alternate mode, this turns on (lit) and off
(dark) the mono mix for the output signal of the
LINE OUTPUT.
For Independent mode, this turns on (lit) and off
(dark) the mono mix for the output signal of the
LINE OUTPUT selected by OUTPUT buttons A–C.
You can confirm the phase or mix balance of the
sound by using this button.
For details on the mode, including how to select
the mode, refer to the "Setup Window" (page 16)
in the section "dspMixFx UR28M" or the "Master
Levels Window" (page 21) in the section
"Dedicated Windows for Cubase Series."
OUTPUT LEVEL knob
Adjusts the output signal level of the LINE
OUTPUT.
When you turn the LINK (page 16) off in the
Independent mode, you can set different output
signal levels to each LINE OUTPUT A–C. Press
one of the OUTPUT buttons A–C then adjust the
output signal level by the OUTPUT LEVEL knob.
At this time, the OUTPUT LEVEL knob setting and
the output signal level are mismatched
immediately after you select the OUTPUT buttons
A–C. When you adjust the OUTPUT LEVEL knob,
the output signal level is applied immediately.
Panel Controls and Terminals (Details)
CAUTION
When you turn the LINK off, and set the a significant
different signal level for each LINE OUTPUT A–C, a
high volume level may be produced suddenly by
turning the OUTPUT LEVEL knob, possibly causing
hearing loss or device damage.
MUTE button
For Alternate mode, this turns on (lit) and off
(dark) muting of the LINE OUTPUT signal.
For Independent mode, this turns on (lit) and off
(dark) muting of the LINE OUTPUT signal
selected by OUTPUT buttons A–C.
For details on the mode, including how to select
the mode, refer to the "Setup Window" (page 16)
in the section "dspMixFx UR28M" or the "Master
Levels Window" (page 21) in the section
"Dedicated Windows for Cubase Series."
Power button
Turns the power on and off.
Power on Press the power button ( ). The
power button will light.
Power off Hold down the power button ( )
for over two seconds. The power
button will light dimly.
Word clock source lamp
Indicates the word clock (page 33) source of the
device.
Lamp Clock Source
S/PDIF The word clock signal input to S/
PDIF IN.
INTERNAL The internal word clock signal.
Lamp status Description
Lit Synchronized with the clock
source.
Flash Not synchronized with the clock
source.
To select the clock source of the device, use the
"(device name) Window" (page 10) in the section
"Control Panel of the Audio Driver" in Windows or
Audio MIDI Setup in Mac.
Operation Manual
UR28M
9