Steinberg UR28M Operation Manual page 36

*1The following chart indicates an effect insertion location.
Upper (INS.FX)
From input on the device
Effect
To DAW
input
To output on the device
*2 One of the MIX 1–3 signals can be sent to the REV-X.
*3 The built-in REV-X is equipped with an "FX Bus" which is used for sending the signal from DAW software to
the REV-X. For example, to send the recorded audio data to the REV-X, you can check the sound with the
REV-X, which is used for monitoring during the recording.
*4 To select the output signal for LINE OUTPUT A–C, use the buttons on the device . The following charts
indicate the structures.
You can apply four Channel Strips to mono channels, or two Channel Strips to a stereo channel.
Limitations on the use of effects
The maximum number of Channel Strip and Guitar Amp Classics iterations which can be used simultaneously
are limited to the following. For example, Channel Strip can be used for two mono channels, while Guitar Amp
Classics can be used for one mono channel simultaneously.
Channel Strip
Mono
4
2
2
0
0
Lower (MON.FX)
From input on the device
To DAW
input
Effect
To output on the device
Stereo Mono
0 0
1 0
0 1
2 0
1 1
Not applied (OFF)
From input on the device
To DAW
input
To output on the device
Guitar Amp Classics
Stereo
-
-
-
-
-
Appendix
Operation Manual
UR28M
36