Rear Section - JVC GY-DV500U Instructions Manual

2. CONTROLS, INDICATORS AND CONNECTORS

2-5 Rear Section

q
EARPHONE
w
DC OUTPUT
e
1
[DV] connector
Using a DV cable (optional), a digital video component with
DV connector can be connected here.
This connector is used for input and output of the DV signal
or to input the VCR control signal from the digital video
component with DV connector.
• To record the DV signal from this connector, set the VCR
Setup Menu item No. 126 INPUT SELECT to "IEEE1394".
• To remote control the VCR with a VCR control signal from
this connector, set the VCR Setup Menu item No. 050
REMOTE SELECT to "IEEE1394".
2
[EAR.] earphone jack
This is a stereo mini-jack for connecting an audio monitoring
earphone. Plug in an earphone or headphone with a 3.5
mm diameter plug. (Monaural mini jack)
The earphone can also be used to monitor alarm tones
depending on situations.
The sound from the monitoring loudspeaker is interrupted
when an earphone is connected here.
Memo:
Only the left-channel sound is heard when a stereo mini-
jack is used.
3
[DC OUTPUT] connector
Power output connector to a wireless microphone
transmitter, etc. The supply voltage is identical to the voltage
supplied to the unit (DC 12V max. 0.1 A).
4 1
3 2
(Surface profile)
20
0
i
o
CH-1 AUDIO IN CH-2
DV TALLY
LINE MIC LINE MIC u
+48V +48V
ON ON
DC INPUT
r t y
No. Signal
1
GND
2
—
3 —
4
DC +12V (power through)
!1
PUSH
DV CAMCORDER
GY-DV500
Y/C OUT MONITOR OUT LINE OUT
CH-1 CH-2
4
[DC INPUT] connector (XLR 4-pin)
Power input connector for 12 V DC. Connect with the AA-
P250 optional AC power adapter. When a cable is connected
here, the power supply from the battery pack is interrupted
and the source is switched to the power supplied through
this connector.
1 4
2 3
5
[CH-1 AUDIO IN] CH-1 audio input connector (XLR
3-pin)
Connect the external audio equipment or microphone to
this connector. Set the CH-1 AUDIO IN LINE/MIC select
switch 8 according to the connected equipment.
The audio signal input through this connector is recorded
on the CH-1 audio channel. To record the audio of this
connector, set the CH-1 AUDIO INPUT switch 7 on page
14 to "REAR".
(AUDIO IN connector)
2 1
3
SYNC IN TEST OUTPUT
B
VTR
REMOTE
MIC
LENS
BREAKER
Bottom side
No. Signal
1
GND
2
—
3 —
4
+12V
No. Signal
1 GND
2 HOT
3 COLD