Using An Anton-Bauer Battery Pack - JVC GY-DV500U Instructions Manual

4-2 Battery Pack Operation (Cont'd)

Using an Anton-Bauer Battery Pack

To use an Anton-Bauer battery pack (Propack 13/14, Trimpack 13/14, Magnum 13/14, Compack 13/14 Series), it is necessary to
detach the battery case from the GY-DV500 and replace it with the Anton-Bauer battery holder. Use the following battery holder.
• Battery holder: Anton-Bauer QRQ27
Detaching the Battery Case From the GY-DV500 and Attaching The Anton-
Bauer Battery
1.
Black screw A
1.
Remove the two black screws A on the battery case.
2.
Remove the lower half of the battery case cover in the
downward direction.
3.
Mount screw B
3.
Mount screw B
3.
To remove the battery case, remove the four screws B fixing
the battery case and the connector connecting the battery
case to this unit.
Attaching and Detaching an Anton-Bauer Battery Pack
Guide pins
Release lever
Cassette cover
side panel
Side panel
with display
3.
Connector
Guide
Battery pack
holes
(Trimpack)
(x3)
Attaching the Anton-Bauer Battery Holder
Anton-Bauer Battery Holder
Anton-Bauer
Battery holder
4.
Connect the connectors protruding from the GY-DV500 with
the connectors on the battery holder.
* Following connection of the connectors, insert them into
the connector compartment and secure with the clamp.
5.
Secure the battery holder to the GY-DV500 with the four
mount screws provided with the battery holder.
* Take care not to pinch the wires. This could result in
damage.
Release
Attaching the Battery Pack
lever
1.
Align the 3 guide pins of the battery pack with
the guide holes on the battery holder, and push
straight to insert the battery pack.
LIGHT
ON
OFF
The battery cannot be attached properly if the
COUNTER
CTL
TC
UB
guide pins are not inserted straight.
2.
Slide the battery pack toward the side panel
where the cassette cover is located until it clicks.
Now the battery pack has been attached.
Battery
Detaching the Battery Pack
While pushing and holding the release lever, slide
the battery pack toward the side panel where the
LCD display is located, then pull the battery pack
outward to remove.
4. POWER SUPPLY
Connector
Compartment
37