Table of Contents
Advertisement
MAN-MAXPRO
REV. B.0.
8. MAINTENANCE
8.1
Open battery compartment by turning the screw (See
Figure 15) a half turn counterclockwise to release.
8.2
•
•
•
•
•
8. MAINTENANCE
BATTERY INSTALLATION
Use only MPRO NiMH rechargeable battery pack or
MPRO alkaline battery holder with 4 each of the following
alkaline cells only: Duracell Pro-cell-2400, Duracell MN-
2400 and Eveready E-92 or EN-92. Observe proper
polarity when installing alkaline batteries.
Do not change batteries in a hazardous location.
ALKALINE BATTERY PACK
INSTALLATION
Refer to Section 8.1 Battery Installation.
Remove existing battery pack.
Insert 4 approved alkaline cells into the supplied alkaline
battery holder. Observe the polarity indicated in the holder
when inserting each cell.
Insert alkaline battery holder, with 4 approved AAA cells, into
the battery compartment. Observe battery pack contacts
orientation (See Figure 16). This means that the connector
end faces the rear of the instrument where it makes electrical
contact. Once the end with the connector is pushed in, the
rear of the battery pack may be pushed down.
Push down cover and secure with a half turn clockwise on
screw.
CAUTION
64
Advertisement
Table of Contents
