Table of Contents
Advertisement
MAN-MAXPRO
REV. B.0.
to select 4 and depress the ON/OFF switch to accept the 4.
Use MODE to select 5 and ON/OFF to accept and exit this
menu.
The date and time are now correctly set. The "DAYLIGHT
SAVING" time menu now appears.
Default is "OFF". Depress the MODE button to accept this
setting and exit, or depress the ON/OFF button to turn on
daylight savings and exit.
6.5
The data log frequency is the time interval between logged
readings and may be set at 1, 2, 3, 4 or 5 minutes. The time
internal does not affect the total number of data points. The
total number of data points is fixed at 2400 so if a 1-minute
interval is chosen, 40 hours of data may be logged. If a
5-minute interval is chosen, 200 hours of data may be logged.
The default setting is 1-minute so no action need be taken if
this interval is acceptable.
To change the data log frequency, access the supervisory
mode (See Section 6.1 Programming Options) and use the
MODE button to scroll down to "DATA LOG-FREQ". Depress
the ON/OFF button to enter the menu sequence, then use the
MODE button to select 1,2,3,4 or 5-minute interval. Depress
the ON/OFF button to accept the selection and exit.
6.6
The factory default setting is automatic zeroing during start-up,
each time the instrument is turned on. If this is not acceptable,
the auto-zero function during start-up may be turned off by
entering the supervisory mode (Section 6.1 Programming
Options) and using the MODE button to scroll down to:
6. PROGRAMMING
DAYLIGHT SAVING
OFF
SELECTING DATA LOG FREQUENCY
AUTO-ZEROING
AUTO ZERO
ON
34
Advertisement
Table of Contents
