Setup-Functions - Kemppi MasterTig MLS 3000 ACDC Operating Manual

3.5

seTup-FunCTiOns

SETUP-function
Upslope current dependency
(*C)
Downslope current
dependency (*C)
TIG Antifreeze (*C)
MMA Antifreeze (*C)
VRD (*C)
2T downslope cut off
Tacking automatics
Limitation of rate of current
rise with high currents
MMA/TIG method selection
EN
with remote control (C*)
SearchArc On/Off
Current freeze function
Memory channel selection with
Plus/Minus buttons (C*)
Activation of the Plus/Minus
buttons (C*)
Water cooler flow guard (C*)
Water cooler automatic control
(C*)
Water cooler temperature
guard (C*)
Automatic remote control
device recognition (C*)
Tail arc
18
*C = Common: applies to all memory channels
Display
Factory setting with a grey background
A1 ON The upslope time is determined by the current.
OFF The upslope time remains as set.
A2 ON The downslope time is determined by the current.
OFF The downslope time remains as set.
A3 ON TIG Antifreeze on.
OFF TIG Antifreeze off.
A4 ON MMA Antifreeze on.
OFF MMA Antifreeze off.
A7 ON VRD mode: idle voltage < 35 V
OFF Normal idle voltage (3000: 63 V, 3003: 58 V)
A8 ON In 2T mode, cut off the downslope with a quick push of the start
button.
OFF Quick push has no effect.
A9 ON If welding has lasted less than 3 seconds, no downslope when
welding is stopped.
OFF Tacking automatics off.
A10 ON If the current is over 100 A and UpSlope is 0.0 sec., there is a 0.2-
second slope from half the welding current.
OFF Current rises directly to indstillet værdi.
A12 ON TIG = the start of remote control scale.
MMA = the end of the scale.
OFF Remote control as a normal current regulator.
A13 ON SearchArc on.
OFF SearchArc off.
A14 ON During the slope, the current can be 'frozen' at a certain level (4T
and Minilog) by pushing the start button.
OFF Freeze function off.
A15 ON The Plus/Minus buttons on the remote control RTC20 can be used
to select the memory channel.
OFF The buttons adjust the current.
A16 ON The Plus/Minus remote control (RTC20) is always active.
OFF The Plus/Minus remote control is active only when selected by
pressing the REMOTE button.
A17 ON Flow guard on.
OFF Flow guard off.
A19 ON Automatic control on.
OFF Water cooler runs constantly.
A20 ON Water cooler temperature guard selected.
OFF Temperature guard off.
A21 ON Automatic recocnition on, control cannot be selected if it is not
connected.
OFF Automatic recocnition On/Off. Controller can be selected even if it
is not connected.
A22 ON* Tail arc on. * 4T LOG
OFF** Tail arc off. ** MINILOG