Setup Functions - Kemppi MLS 2300 ACDC Service Manual

Setup functions

Entering the advanced setup press and hold the setup and Return buttons at the same
time. Changing the level press Setup button shortly
Welding current upslope time *
Welding current downslope time *
TIG Antifreeze *
MMA Antifreeze *
VRD * (MMA open circuit voltage)
2T-function´s downslope cutoff
Tacking automatics
Current upslope speed
Method selection by remote
controller *
* Setting is always on ** Adjustable also by the Quick Setup
ON The upslope time depends on the welding
current
A1
OFF The upslope time is fixed
ON The downslope time depends on the welding
current
A2
OFF The downslope time is fixed
ON TIG Antirfeeze is ON
A3
OFF TIG Antifreeze is OFF
ON MMA antifreeze is ON
A4
OFF MMA antifreeze is OFF
ON VRD-function: MMA open circuit voltage < 35
Vdc
A7
OFF Normal open circuit voltage is 50 Vdc
ON On 2T-function the downslope is cut off by a
quick press on the start switch
A8
OFF Quick press on the start switch has no function
ON Tacking automatics is ON; no downslope, if the
weld is shorter than 3 s
A9
OFF Tacking automatics is OFF
ON If upslope time is 0,0 s, it goes to 0,2 s from the
halfway of currents > 100 A.
A10
OFF Maximum current upslope speed
ON Method selection; TIG: minimum end of the
range of the remote controller, MMA: the
maximum end of the remote controller range
A12
OFF The remote controller works as a normal current
adjustment
4