Smoke hollow 7000CGS Assembly & Operation page 18

Grill & smoker

Assembly

Step 20

Fig. 21A

Step 21

Fig. 21B

Step 20: Attach Charcoal Damper Handle

Locate: Charcoal Damper Handle

Procedure:

Screw the handle into the hole located above

the vertical slots on the charcoal side of the

grill. The handle should slide back and forth

to open and close the damper.

Step 21: Install Warming Rack

Locate: (2) Warming Rack and (4) M6x25

bolts

Procedure: To attach the warming rack, insert

(1) of the M6x25 bolts through the lid from the

outside as shown in Figure 21A and position

the warming rack so that the bolt is going

through the wire loop as shown in Figure 21B.

Then align the wire loop on the opposite end

of the warming rack with the opposite lid hole

and insert the other M6x25 bolt.

Insert the wire legs into the holes on the sides

of the cabinet as shown in Figure 21C.

Fig. 21C

Table of Contents

Show Quick Links