Advertisement
Assembly
Step 15: Sear Burner Assembly
Step 15
Locate: Sear Burner Housing and Lid (Part
21), Sear Burner, Sear Burner Control Knob,
(5) M6x15 bolts and (2) M4x10 bolts.
Procedure:
Attach the sear burner housing to the left end
of the grill cabinet with (5) M6x15 bolts (See
Figure 15A). Insert (1) M6x15 bolt through the
hole in the grill cabinet and into the sear
burner housing as shown in Figure 15B. Then
insert (2) M6x15 bolts through the sear burner
housing and into the grill cabinet. The last (2)
Fig. 15A
M6x15 bolts are inserted through the
underside of the sear burner housing and
through the leg into the grill cabinet.
The next step is to attach the sear burner
valve to the sear burner housing. Remove the
(2) M4x8 screws from the sear burner valve
as shown in Figure 15C. Then position the
valve in place between the front panel of the
sear burner housing and the inner wall as
shown in Figure 15D. Align the threaded
Fig. 15B
holes in the valve with the holes in the sear
burner housing and attach using the (2) M4x8
bolts that were removed earlier.
Place the sear burner control knob over the
valve stem, making sure to align flat portion of
both components, and push the control knob
over the stem until it is firmly seated. See
Figure 15E. Use this same procedure to
Fig. 15C
install the (3) gas control knobs on the gas
grill control panel.
Fig. 15D
(Sear Burner Assembly continued on next
page)
Fig. 15E
15
Hide quick links:
Advertisement
