Advertisement
Assembly
Fig. 15 F
Fig. 15 H
Fig. 15 J
Step 16
Fig.16A
Fig.16B
Fig. 15 G
Fig. 15 I
Retaining Wire
16
(Step 15: Sear Burner Assembly Continued)
Locate the sear burner, tilt the sear burner up
and slide the tube through the inner wall and
onto the valve as shown in Figure 15F. From the
underside of the sear burner housing, check to
make sure the valve is inside the tube as shown
in Figure 15G.
Now attach the Sear Burner to the bracket
located on the back wall of the Sear Burner
Housing using (2) M4.2 x10 Screws as shown in
Figure 15H.
Remove the large nut from the igniter as shown in
Figure 15I, push the other end of the wire through
the hole into the underside of the housing. And
slide the wire through the nut and through the hole
on the outside of the housing.
Attach the wire to the stem of the igniter. Push
the igniter and wire through the hole and attach it
to the housing by screwing the nut back onto the
igniter. Figure 15J.
Step 16: Attach Retaining Bracket and
Retaining Wire for LP Gas Cylinder
Locate: Retaining Bracket (Part # 24), Retaining
Wire (Part #25) and (2) M6x15 bolts.
Procedure: Attach the retaining bracket to the
left end of the bottom shelf using (2) M6x15 bolts
as shown in Figure 16A.
Attach retaining wire to legs at left end of grill as
shown in Figure 16B. Position the retaining wire
inside the legs and under the grill body with the
curved side up. Then insert the ends of the wire
through the holes in the legs and rotate the wire
toward you.
Hide quick links:
Advertisement
