Smoke hollow 7000CGS Assembly & Operation page 11

Assembly
Step 8
Fig.8
Step 9
Fig. 9A
Fig.9C
Fig.9D
Fig.9E
Fig. 9B
Stop tab
11
Step 8: Install Grease Pan Connector
Locate: Grease Pan Connector and (2)
M6x15 bolts.
Procedure:
Place the grease pan connector inside the left
end of the cabinet just below the horizontal
slot and insert (2) M6x15 bolts from outside
the cabinet as shown in Figure 8.
Step 9: Install the Drip Tray Guides (Right,
Left and Center)
Locate: Left Side Drip Tray Guide, Right Side
Drip Tray Guide, Center Drip Tray Guide and
(10) M6x15 bolts.
Procedure:
Place right side drip tray guide inside the right
legs as shown in Figure 9A and attach using
(4) M6x15 bolts.
Place left side drip tray guide inside the left
legs as shown in Figure 9B and attach using
(4) M6x15 bolts. Be sure the LP gas line is
positioned outside the left drip tray guide as
shown in Figure 9B.
From in front of the grill, find the threaded hole
on the underside of the cabinet and partially
insert an M6x15 bolt as shown in Figure 9C.
Position the center drip tray guide so that the
keyhole fits over the partially installed bolt
(See Figure 9D). Then push the guide toward
the back of the grill cabinet so that the tab fits
over the threaded hole in the lower back side
of the cabinet and insert an M6x15 bolt as
shown in Figure 9E. Fully tighten both M6x15
bolts.