Rx Report - Canon 3300 Series Manual

RX Report

This report is used to check if documents were sent normally from the sending party, or if
documents were received normally by this machine.
You can set whether or not to automatically print an RX report. (See 'Setting Automatic
Output of an RX Report,' on p. 7-6.)
NOTE
•
The default setting for RX Report is "Off". (See 'Setting Automatic Output of an RX Report,' on p. 7-6.)
03/05 2001 MON 13:03 FAX 035 4892 5997
RECEPTION OK
JOB NO.
DESTINATION ADDRESS
PSWD/SUBADDRESS
DESTINATION ID
ST. TIME
USAGE T
PGS.
RESULT
1 REPORT NAME An "RX REPORT" is printed when the sending of documents is completed normally,
and also when a receiving error occurs.
2 MESSAGE A message describing the reception result is printed.
3 JOB NO. The 4-digit number, that is automatically assigned when a receiving document is
accepted, is printed.
4 DEPARTMENT ID If Department ID Management is set, the Department ID is printed.
5 DESTINATION The telephone number of the sending party is printed to the first 20 digits.
ADDRESS
6 SUBADDRESS A subaddress is printed if one is specified.
7 DESTINATION ID The name of the remote party is printed.
8 ST. TIME The date and time (24-hour clock display) at which the documents started to be sent
are printed.
9 USAGE T The time taken (minutes and seconds) from start to end of sending is printed.
10 PGS. The number of pages of the original that were sent normally to the remote party is
printed.
11 RESULT When sending of the documents ended normally, "OK" is printed.
When a sending error occurred, "NG" is printed.
If a sending error occurred, the page number of the page in which the error occurred,
and also the error code number are printed.
CANON

RX REPORT

RX Report
5002
03/05 13:02
00'14
1
OK
Activity Management Reports and Lists
001
.
9
9-5