Reverse Buzzer Limit Switch - Club Car 2005 precendent Maintenance And Service

ELECTRICAL COMPONENTS
3
REVERSE
BUZZER
VIEWED FROM
UNDERSIDE OF
INSTRUMENT
PANEL
2
Figure 12-20 Reverse Buzzer
Reverse Warning Buzzer Installation
1. Install the screws (3) through the buzzer bracket tabs and tighten to 3.5 in-lb (0.40 N·m) (Figure 12-20,
Page 12-19).
2. Connect the black wire (1) from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire (4) from the wire harness to the positive (+) terminal on the buzzer.
4. Install the instrument panel.
4.1. Connect the electrical connector (3) (Figure 12-16, Page 12-13).
4.2. Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly
engage with the corresponding slots on the dash assembly. Ensure that there are no wires exposed
or pinched during positioning.
4.3. Secure instrument panel to the dash assembly with three screws (1). Tighten screws to 1.8 ft-lb
(2.5 N·m).
5. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16.3 N·m).
See Figure 1-1, Section 1, Page 1-3. Coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
6. Shift the Forward/Reverse handle to the REVERSE position. The buzzer should sound.

REVERSE BUZZER LIMIT SWITCH

See General Warnings, Section 1, Page 1-1.
Testing the Reverse Buzzer Limit Switch
See Test Procedure 19, Section 11, Page 11-32.
Reverse Buzzer Limit Switch Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
RED/
WHITE
BLACK
1
4
2005 Precedent Gasoline Golf Car Maintenance and Service Manual
Reverse Buzzer Limit Switch
Page 12-19
12