Driven Clutch; Driven Clutch Removal - Club Car 2005 precendent Maintenance And Service

TORQUE CONVERTER
Figure 17-18 Leaf Spring and Shackles
6. Lower vehicle and remove the lifting device.
7. Install the drive belt as instructed. See Drive Belt Installation on page 17-3.
8. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16.3 N·m).
See Figure 1-1, Section 1, Page 1-3. Coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
9. Connect the spark plug wire to the plug.
10. Drive the vehicle and check for proper operation.

DRIVEN CLUTCH

See General Warnings, Section 1, Page 1-1.

DRIVEN CLUTCH REMOVAL

1. Remove the drive belt as instructed. See Drive Belt Removal on page 17-2.
2. Remove the access panel on the rear of the vehicle.
3. Remove the bolt (11) and mounting washer (12) from the clutch shaft (Figure 17-22, Page 17-15).
4. Grasp the driven clutch assembly and slide it off the shaft.
5. Leave the key (9) in the keyway.
2005 Precedent Gasoline Golf Car Maintenance and Service Manual
Figure 17-19 Shock Absorbers
17
Driven Clutch
Page 17-13