Programming Sequence - PSC Universal Keyboard Wedge Programming Manual

Programming Sequence

1. Read the START bar code located on the
inside back cover of this manual to enter
Programming Mode.
2. Phase A -- START OF CONSTRUCTION.
Select a format number #N (FORMAT
#1-4) to construct by scanning its associ-
ated bar code.
3. Phase B -- Set up the MATCH CONDI-
TION. Before editing data, scan the
appropriate bar codes to define each of
these four criteria for the input data:
- Match with symbology (not available for all
scanner models)
- Match with number of characters
- Match with input port
- Match with pre-defined characters
R44-2021
EDITING MODE
49