PSC Universal Keyboard Wedge Programming Manual page 25

Cloning Mode - continued
7. Power-off the target scanner, and connect
the next target scanner. Repeat steps 2
through 6.
When cloning multiple scanners, it is
not necessary to read the TRANS-
MIT CONFIGURATION bar code
(step 5) each time a different target
scanner is connected. Simply scan
the RECEIVE CONFIGURATION
bar code in step 6 as each target
scanner is connected for cloning.
To exit Cloning Mode, power the source scanner
off, then on.
R44-2021
COMMUNICATION MODES
NOTE
19