PSC Universal Keyboard Wedge Programming Manual page 15

How to Program Your Scanner - continued
2. Select the desired interface. This manual
offers only two selections for this:
a) The Universal Keyboard Wedge interface
(see the Universal Keyboard Wedge Interface
Configuration section).
b) The RS-232 interface (see the RS-232
Interface Configuration section).
3. Scan the bar codes from the appropriate
section (Universal Keyboard Wedge Interface
Configuration or RS-232 Interface Configura-
tion) to select options and modify features
for the selected interface type.
If the scanner's beeper is enabled, it
will emit a "good read" beep as each
bar code is read successfully.
4. After all desired programming param-
eters have been set, you must end the
session by scanning the END bar code
located on the inside back cover of this
manual.
R44-2021
INTRODUCTION
NOTE
9