If You Make A Mistake - PSC Universal Keyboard Wedge Programming Manual

If You Make a Mistake...

If, during a programming session, you find that you
are unsure of the scanner's Universal Keyboard
Wedge settings or wish to re-set this configuration,
use the Return to Factory Settings bar code on the
next page to return all Universal Wedge parameters
to their factory settings. Scanning this bar code will
also reset any Universal Wedge changes made
during previous programming sessions.
When your scanner is first connected
to a keyboard wedge host, the factory
default setting (unless your scanner
was custom configured) is communi-
cation with a U.S. PC/AT keyboard.
Use the FACTORY DEFAULTS bar
code with caution, since it will dis-
able/reset ALL Universal Wedge fea-
tures that may have been pro-
grammed since the scanner's instal-
lation.
R44-2021
NOTE
CAUTION
INTRODUCTION
11