Table of Contents
Advertisement
7.2.6 Adjusting the advanced blend drop-off curve
The drop-off curves can be configured individually for advanced blend. Click on a control
point in the blend zone you would like to adjust, or select multiple points or blend zones with
by dragging a selection rectangle over the areas of interest. Then select "Drop-off Curve" in
the Calibration panel toolbar. Adjust the drop-off curve with the vertical and horizontal sliders,
as illustrated in Figure 7-5.
Figure 7-5. Adjusting the blend drop off curve.
39
Advertisement
Table of Contents
Need help?
Do you have a question about the FUSION and is the answer not in the manual?
Questions and answers