Parameter Broadcast; Single Point/Multipoint Operation - Symbol LS3478-FZ Reference Manual

Parameter Broadcast

Enable Parameter Broadcast to broadcast all parameter bar codes scanned to all other scanners in the piconet. If disabled, parameter
bar codes are processed by the individual scanner only, and the scanner ignores parameters broadcast from other scanners or from
the cradle (e.g., parameters sent via 123Scan).

Single Point/Multipoint Operation

The cradle supports communication from up to four scanners simultaneously. This multipoint mode requires an external power supply
to charge the scanners in the cradle. To power the cradle from the interface cable (either from the USB hub or from a power supply
attached to the interface cable), place the cradle in single point mode. In single point mode, only one scanner can connect to the
cradle at a time.
When operating in bus-powered mode, the cradle must turn off the Bluetooth radio to charge the scanner. For
this reason, only charge the scanner paired with the cradle in the cradle. Placing another scanner in the cradle
for charging disrupts communication with the paired scanner.
When setting options while in multipoint mode, allow time for the setting changes to apply to all scanners.
To select single point or multipoint mode, scan the appropriate bar code.
*Enable Parameter Broadcast
Disable Parameter Broadcast
Multipoint Mode
*Single Point Mode
User Preferences 4-13