Related Manuals for Symbol LS3478
Summary of Contents for Symbol LS3478
- Page 1 Symbol LS3478/3578 Scanner Troubleshooting & Configuration Guide Issue: 1 Date 29/07/2009 Page 1 of 6...
- Page 2 Health Edge Notice This document contains information from Health Edge Solutions Ltd which is confidential. The information is intended to be for the use of the Health Edge Solutions Ltd customer. Any disclosure, copying, distribution or use of the contents of this information is prohibited unless explicitly authorised by an authorised representative of Health Edge Solutions Limited.
- Page 3 Contents Table of Contents Chapter 1 - Troubleshooting ......................4 Chapter 2 – Scanner Configuration Sheet ..................8 Issue: 1 Date 29/07/2009 Page 3 of 6...
-
Page 4: Troubleshooting
Try scanning test bar codes of the same bar Bar code symbol is unreadable. code type. Bar code is out of range from Move scanner closer to or the scanner. - Page 5 Problem Possible Causes Possible Solutions Scanner emits four long low Cradle has not completed USB Wait several seconds and scan beeps after scanning a bar initialization. again. code. Power cables to cradle are Ensure all cable connections loose. are secure. Scanner is not paired to a Scan the PAIR bar code on the cradle.
- Page 6 Chapter Scanner Configuration Sheet Use the barcodes in the steps below to configure/reconfigure the Symbol LS3478 IP65 Scanner. 1. Scan the Enter barcode. 2. Now scan the barcode on the top of the base unit. 3. Scan the Scan Options barcode.