Rts Line State; Beep On <Bel - Symbol LS3478-FZ Reference Manual

RS-232 Interface 6-19

RTS Line State

This parameter sets the idle state of the Serial Host RTS line. Scan a bar code below to select Low RTS or High RTS line state.
*
Host: Low RTS
Host: High RTS
Beep on <BEL>
Single Point Mode Only
When this parameter is enabled, the scanner issues a beep when a <BEL> character is detected on the RS-232 serial line. <BEL> is
issued to indicate an illegal entry or other important event.
This parameter is not supported in Multipoint mode.
Beep On <BEL> Character
(Enable)
*
Do Not Beep On <BEL> Character
(Disable)