Setup Field(S) - Symbol LS3478-FZ Reference Manual

Setup Field(s)

Parameter
Move Cursor
Move Cursor to a Character
Move Cursor to Start of Data
Move Cursor Past a Character
Skip Ahead "N" Characters
Skip Back "N" Characters
Send Preset Value
Table 14-1. Setup Field(s) Definitions
Description
Scan the Move Cursor To Character
then any printable ASCII character from the
Keyboard. When this is used, the cursor moves to the position
after the matching character. If the character is not there, the rule
fails and ADF tries the next rule.
Scan this bar code to move cursor to the beginning of the data.
This parameter moves the cursor past all sequential occurrences
of a selected character. For example, if the selected character is
'A,' then the cursor moves past 'A,' 'AA,' 'AAA,' etc. Scan the
Move Cursor Past Character
select a character from the Alphanumeric
character is not there, the cursor does not move (i.e., has no
effect).
Scan one of these bar codes to select the desired number of
positions to move the cursor ahead.
Scan one of these bar codes to select the desired number of
positions to move the cursor back.
Send prefix and/or suffix value by scanning the appropriate bar
code. These values must be set using the Scan Prefix and Scan
Suffix bar codes on page 13-5.
bar code on page 14-24, 14-24
Alphanumeric
14-24
14-24
bar code on page 14-24, then
Keyboard. If the
14-24
14-26
14-27
Advanced Data Formatting 14-23
Page