Step 6: Plug In The Washer - ALLIANCE Metered Installation And Operation Manual

Installation

Step 6: Plug In the Washer

Electrical Requirements
(120 Volt, 60 Hertz with 3-Prong Grounding Plug)
NOTE: The wiring diagram is located in the
control hood.
WARNING
To reduce the risk of fire, electric shock,
serious injury or death, all wiring and
grounding MUST conform with the latest
edition of the National Electrical Code,
ANSI/NFPA No. 70, and such local
regulations as might apply. It is the
customer's responsibility to have the
wiring, fuses and circuit breakers
installed by a qualified electrician to make
sure adequate electrical power is
available to the washer.
When plugging in the washer:
DO NOT overload circuits.
●
DO NOT use an extension cord.
●
DO NOT use an adapter.
●
DO NOT operate other appliances on the same
●
circuit. Use separately fused 15 Amp circuits.
The washer is designed to be operated on a separate
branch, polarized, three-wire, effectively grounded,
120 Volt, 60 Hertz, AC (alternating current), circuit
protected by a 15 ampere fuse, equivalent fusetron or
circuit breaker.
The three-prong grounding plug on the power cord
should be plugged directly into a polarized three-slot
effectively grounded receptacle rated 110/120 Volts
AC (alternating current) 15 Amps. Refer to Figure 10
to determine correct polarity of the wall receptacle.
12
W518
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
2
1
120±12
V.A.C.
120±12
V.A.C.
Standard 120 Volt, 60 Hertz
3-Wire Effectively
Grounded Circuit
1 L1
2 Ground
3 Neutral Side
4 Round Grounding Prong
5 Neutral
Figure 10
WARNING
To reduce the risk of an electric shock or
fire, DO NOT use an extension cord or an
adapter to connect the washer to the
electric power source.
3
0 V.A.C.
5
4
DRY2022N
W082
201932