Vending; Meter Case; Slide Extension - ALLIANCE Metered Installation And Operation Manual

Installation

Vending

Meter Case

The factory mounted coin meter case does not include
the service door lock, coin slide, coin drawer, coin
drawer lock or keys. These parts must be ordered (at
extra cost) according to the purchaser's requirements
direct from the manufacturer of your choice.
NOTE: On models with standard capacity meter
case, you have the option of using a screw type lock
or a 1/4 turn lock on the meter case service door. If
you choose to use a screw lock, then the special
bracket (located inside the meter case) must be
used. DO NOT use the special bracket if a 1/4 turn
lock is used. Models with high capacity meter case
use 1/4 turn lock only.
Coin Drawer Security (Models with Standard
Capacity Meter Case Only) – For additional security,
drill out the two pilot holes on each side of the front of
the meter case to 1/4 or 5/16 inch (6.4 or 7.9 mm)
holes and install a bicycle lock through these holes.
NOTE: An 8 in. (20.32 cm) coin drawer is required
for coin operated electronic control models with
standard capacity meter case. Models with high
capacity meter case require a 7.21 in. (18.31 cm)
coin drawer.

Slide Extension

(Coin Slide Models with Standard Capacity Meter
Case Only)
NOTE: Models with high capacity meter case
require a coin slide with a switch installed on it.
1. Remove slide extension parts from parts
accessories bag included in unit.
14 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
2. If installing a Greenwald coin slide, position
extension lever (to be installed on extension
bracket) with arm that has one star facing down.
Refer to Figure 13.
Greenwald
Coin Slide
One Star
Figure 13
3. If installing a Monarch or ESD coin slide,
position lever with arm that has two stars facing
down. Refer to Figure 13.
4. Install extension lever with rounded corner facing
away from extension bracket using bolt, one or
two flat washers (shims) (use number of washers
included in kit) and nut. Refer to Figure 14. Make
sure washers are flat against bracket.
Bolt
Spring
Loops
Extension Bracket
Star(s) Facing Down
Figure 14
5. Torque nut between 2 and 2.26 Nm (18 and 20
inch-pounds), or tighten nut firmly.
6. Install extension spring in bracket hole and hole in
upper arm of lever. Refer to Figure 14.
7. Bend loops closed after installation.
8. Check to make sure the lever swings freely.
Monarch or
ESD Coin Slide
Two Stars
TLW2088N
One or Two
Flat Washers (Shims)
Rounded Corner
Nut
Extension Lever
TLW2089N
TLW2089N
201932