Table of Contents
Advertisement
Installation
Step 9: Plug In the Washer
Refer to section on Electrical Requirements and plug
the washer in.
Figure 13
Step 10: Check Installation
Refer to Installer Checklist on the back cover and
make sure that washer is installed correctly.
18
D254I
D254I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Moving Washer to a New Location
To prevent damage while moving the washer, the
shipping materials MUST be reinstalled.
Reinstallation of Shipping Materials
Disconnect washer from electrical supply.
Remove front access panel by removing two screws.
Place the shock sleeves on all four shock absorbers.
Refer to Figure 14.
Insert hooked end of shipping brace into the open slot
of the motor mount. Attach with bolts and lockwashers.
Refer to Figure 14.
Reinstall front access panel.
4
3
1
Shock Sleeves
2
Motor Mount
3
Bolts and Lockwashers
4
Hooked End of Shipping Brace
Figure 14
Refer to step 6 for proper procedures whenever the
washer is moved.
1
2
H336I
801479
Advertisement
Table of Contents
