ALLIANCE Metered Installation And Operation Manual
Automatic washer
Hide thumbs
Also See for Metered:
- Installation and operation manual (108 pages) ,
- Installation & operation manual (54 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ALLIANCE Metered
Summary of Contents for ALLIANCE Metered
- Page 1 Automatic Washers Metered and Nonmetered Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com. W446I Keep These Instructions for Future Reference. (If this machine changes ownership, this manual must accompany machine.) Part No. 201932R3 www.comlaundry.com August 2008...
- Page 3 W022 IMPORTANT: Read the complete INSTALLATION/OPERATION INSTRUCTIONS before using the washer. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 201932...
-
Page 4: Table Of Contents
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... - Page 5 Replacing Hoses................31 Filter Screens ................... 31 Reinstallation of Shipping Materials ..........31 Motor Overload Protector..............31 Troubleshooting .................. 32 Contact Information................34 Installer Checklist............... Back Cover 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
-
Page 6: Safety Information
8. Do not reach into the washer if the washtub or agitator is moving. 9. Do not install or store the washer where it will be exposed to water and/or weather. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... - Page 7 20. Be sure water connections have a shut-off valve and that fill hose connections are tight. CLOSE the shut-off valves at the end of each wash day. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
-
Page 8: Installation
TLW2051N Pilot Hole 21.56 in. (54.76 cm) 0.44 in. 25.63 in. (65.1 cm) 26 in. (66.04 cm) (1.12 cm) 28 in. (71.12 cm) TLW2050N NONMETERED MODELS TLW2050N 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 9: Before You Start
IMPORTANT: Install dryer before washer. This allows room for attaching exhaust duct. TLW2052N TLW2052N Shipping Brace Shipping Plug Cardboard Base Figure 2 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 10: Step 2: Wipe Out Inside Of Washtub
This will release any accumulated hydrogen gas. The gas is flammable, do not smoke or use an open flame during this time. W029 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 11: Connecting Hoses
All hoses should be checked on a monthly basis for any visible signs of deterioration. Any hose showing the signs of deterioration listed above should be replaced immediately. All hoses should be replaced every five years. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 12: Step 4: Connect Drain Hose To Drain Receptacle
Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 13: Step 5: Position And Level The Washer
Place rubber cups on all four leveling legs. Place a level on the cabinet top and check if the washer is level from side to side and front to back. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 14: Step 6: Plug In The Washer
110/120 Volts AC (alternating current) 15 Amps. Refer to Figure 10 to determine correct polarity of the wall receptacle. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 15: Step 7: Add Water To The Washer
NOTE: The agitator should not be removed except for service. The washtub is designed to be self- cleaning. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 16: Vending
6. Install extension spring in bracket hole and hole in upper arm of lever. Refer to Figure 14. 7. Bend loops closed after installation. 8. Check to make sure the lever swings freely. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 17: Models Prepped For Card Reader
Refer to blue” wire together. Figure 16. FLW6R TLW2090N Control Panel TLW2090N Lever Off Switch Figure 17 Figure 16 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 18: Additional Washer Security
3. Tilt control panel forward and lay on a protective pad to prevent scratching of cabinet top. 4. Insert Phillips head screw down through double “D” hole in left rear corner of cabinet top (inside 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 19: Operation
If desired, fabric softener may be added to rinse water Figure 20 when RINSE light comes on. Step 3: Close Lid Washer will not operate with lid open. W395I W394I Figure 19 Figure 21 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 20: Step 4: Set Wash Temperature And Fabric/Cycle Selector
Settings with asterisk (*) are Energy Saving Cycles. TLW2045N Figure 22 TWO SPEED PERM PRESS WASHERS DELICATE NORMAL DELICATE NORMAL PERM PRESS FABRIC SELECTOR TLW2083N TLW2083N Figure 24 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 21: Step 5: Start Washer
W092 TLW2048N The washer will stop (pause) shortly before the first spin and final spin. Figure 26 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 22: Control Modes
In Run Mode, the control is running a cycle. The IN reached. USE LED will be lit. For metered models, any time the Drain Error control receives a coin slide pulse during a cycle, the... -
Page 23: Rapid Advance
From final spin, cycle will advance to End of ● Cycle Mode. Open lid to clear End of Cycle Mode and return ● to Ready Mode. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 24: Operation Instructions For Electronic Display Control Washers
If desired, fabric softener may be added to rinse water W392I when RINSE light comes on. Figure 28 Step 3: Close Lid Washer will not operate with lid open. W395I Figure 27 H338I Figure 29 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 25: Step 4: Choose Small Load, If Desired
LID MUST BE CLOSED TO START Step 5: Set Fabric Selector WASHER. Push touchpad for NORMAL, PERM PRESS or DELICATES. Light indicates selection. W387I W338IE0B Figure 33 Figure 31 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 26: Indicator Lights
It will light at the start of the cycle and remain lit until the cycle is completed. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 27: Operation Instructions For Mdc Washers
If desired, fabric softener may be added to rinse water when RINSE light comes on. W392I Figure 35 Step 3: Close Lid Washer will not operate with lid open. W395I Figure 34 H338I Figure 36 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 28: Step 4: Choose Small Load, If Desired
Step 5: Set Fabric Selector and Wash Insert card into opening. Temperature Push touchpad for NORMAL/HOT, NORMAL/ WARM, PERM PRESS/WARM or DELICATES/ COLD. Light indicates selection. FLW1920N FLW1920N Figure 38 DRY1927N Figure 40 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 29: Step 7: Start Washer
RINSE is lit at the beginning of the Rinse cycle and will remain lit until the cycle is complete. SPIN SPIN is lit for all Spin cycles. FLW1923N Figure 41 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 30: Operation Instructions For Netmaster Washers
If desired, fabric softener may be added to rinse water when RINSE light comes on. W392I Figure 43 Step 3: Close Lid Washer will not operate with lid open. W395I Figure 42 H338I Figure 44 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 31: Step 4: Choose Small Load, If Desired
The SMALL LOAD indicator light will be off. Push touchpad for HOT, WARM or COLD. Light indicates selection. W525I W525I Figure 47 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 32: Step 7: Insert Money Or Card
REMOVE CARD (Card Models Only) REMOVE CARD flashes after the START pad has been pressed and the vend has been deducted from the card. M343I Figure 49 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 33: Maintenance
If the overload protector stops motor again, remove the Order filter screen Part No. F270300 from the nearest washer from use and call the service person to correct authorized parts distributor. the problem. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 34: Troubleshooting
• Check the laundry room fuse or circuit breaker. • The motor overload protector may have stopped the cycle. It will reset itself in two or three minutes and restart the washer automatically. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... - Page 35 “H” on the valve bracket) and cold faucet is connected to cold mixing valve (indicated with “C” on the valve bracket). • Make sure laundry room water heater is adjusted properly. 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT...
-
Page 36: Contact Information
If replacement parts are required, contact the source from where you purchased your washer or call (920) 748-3950 for the name and address of the nearest authorized parts distributor. W138P W138P Nameplate Figure 52 201932 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT... -
Page 38: Installer Checklist
Installer Checklist Fast Track for Installing the Washer (Refer to the manual for more detailed information) ➊ ➎ • Remove the • Position and LEVEL Shipping Brace and Level the D255I Shipping Plug. Washer. CHECK CHECK W316IE0A TLW520N TLW520N ➏ ➋...
Need help?
Do you have a question about the Metered and is the answer not in the manual?
Questions and answers