Step 5: Start Washer; Indicator Lights - ALLIANCE Metered Installation And Operation Manual

Step 5: Start Washer

Metered Models
Insert money. Place coin(s) in slide and carefully push
in as far as possible and then pull slide out as far as
possible. (IN USE light will come on indicating start of
cycle.)
Figure 25
Nonmetered Models
Push start switch (IN USE light will come on
indicating start of cycle.)
Figure 26
201932
W297I
TLW2048N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Indicator Lights

IN USE
This light will remain on while washer is in use.
RINSE
This light will be on during the rinse portion of the
cycle.
SPIN
This light will be on during the rinse/final spin only.
Washer will stop automatically at end of cycle. (SPIN
and IN USE lights will go out indicating end of cycle.)
Leave lid open after removing laundry.
IMPORTANT: If washer fails to operate properly
after installation, make sure electrical service and
water supply faucets are turned on. Are all the
controls properly set? Have a qualified service
person refer to the wiring diagram (located inside
of washer control hood), check for broken, loose or
incorrect wiring.
Should washer stop, but IN USE, RINSE or SPIN light
remain on, the motor overload protector may have
cycled. Refer to Maintenance section.
WARNING
To reduce the risk of bodily injury, do not
remove laundry from washer until all
lights are out, and all moving parts have
stopped.
The washer will stop (pause) shortly before the first
spin and final spin.
Operation
W092
19