Configure The Nightringer Parameters - CyberData 11272 Operation Manual

2.4.7 Configure the Nightringer Parameters

When the Nightringer is enabled, the Intercom will register as a second SIP extension. Registration
does not have to be to the same server as the primary SIP registration. Any calls made to the
Nightringer extension will cause the Intercom to play a ring tone. There is no way to answer this call.
The Nightringer is designed to be used in buildings where calls made after hours are directed to a
ring group.
GENERAL ALERT
1. Click on the Nightringer button to open the Nightringer Configuration page. See
Operations Guide
Caution
Nightringer requires SIP Registration. Nightringer cannot be used in peer to peer
mode.
Figure 2-17. Nightringer Configuration Setup
CyberData Indoor Intercom
930853D
Installing the VoIP Flush-Mount Indoor Intercom
CyberData Corporation
34
Intercom Setup
Figure 2-17.