Yamaha YZF-R1P Service Manual page 89

Pass the filter of throttle body
A K
through the hole of rubber
baffle and release it under
the ignition coil plate.
Route the sub lead coupler
A L
behind the ignition coil.
Pass the camshaft position
A M
sensor lead through the hole
of COVER 1 and connect it.
After branching the harness,
A N
clamp each lead of the (+)
lead junction, starting circuit
cut-off relay, atmosphere
pressure sensor, lean angle
cut-off switch flasher relay in
the lump. Do not clamp the
ALARM coupler lead.
CABLE ROUTING
Press the lead of the coupler
A O
for ALARM in under the cou-
pler of ECU.
Pay attention not to allow the
A P
lead to slack and get caught
after wiring when assembling
the side cover.
Make sure to hook the har-
A Q
ness on the hook of battery
box.
Pick-up coil lead
A R
(Should be wired in front of
the clamp.)
Neutral switch lead
A S
(Should be wired in front of
the clamp.)
2 - 39
SPEC
Fasten the (+) lead junction
A T
lead by hooking on the pawl
of the box battery.
Push the (–) lead coupler
A U
into the down side of wire
harness clamp.
Pull in the lead to the posi-
A V
tion inside the frame until the
different color tape attached
to the lead is invisible out-
side the frame bottom edge.