Yamaha YZF-R1P Service Manual page 87

È Route the horn lead under the
rib of bracket horn positioning
the stepped part of protector
outside the rib.
É Make the horn lead face the
outside.
Ê Route the handlebar switch lead
along the groove of the guide-air.
Ë Handlebar switch (right) lead
coupler.
Ì Fasten the wire harness and
coolant temperature
lead with the clamp inserted to
the frame. Point the clamp tip
downward.
Í To starter motor
Î To pick-up coil
Ï To fuel pump
Ð Insert the holding clamp of the
wire harness to the frame.
Route the starter motor lead
and crankshaft position sensor
lead under the throttle body.
Ñ Wiring section #
Ò Connect the leads behind the
clamp. (without
position sensor lead)
Fasten the wire harness, speed
sensor sensor, neutral switch, rear
brake switch, pick-up coil and
starter leads with the clamp
inserted to the frame.
Ó EXUP servo motor
Ô To rectifier regulator
2 - 37
CABLE ROUTING
Õ Fasten the wire harness, (–)
lead, AC magneto lead and
rectifier regulator lead junction
with the clamp inserted to the
box battery.
Ö Fasten the wire harness, AI
system lead, AC magneto lead,
oil level gauge lead, sidestand
crankshaft switch lead and injector sub
lead with the clamp inserted to
the frame.
× Pay attention to the direction of
installation.
Ø Connect the leads between the
clamp and the junction.
Ù Route the (–) and AC magneto
leads under the wire harness.
SPEC