Installing The Clutch - Yamaha YZF-R1P Service Manual

CLUTCH
2. Check:
• starter clutch operation
M MMM M MMM M M MMM M
a. Install the starter clutch drive gear onto the
starter clutch and hold the starter clutch.
b. When turning the starter clutch drive gear
clockwise È, the starter clutch and the
starter clutch drive gear should engage,
otherwise the starter clutch is faulty and
must be replaced.
c. When turning the starter clutch drive gear
counterclockwise É, it should turn freely,
otherwise the starter clutch is faulty and
must be replaced.
L LLL L LLL L L LLL L
EAS00299

INSTALLING THE CLUTCH

1. Install:
• clutch boss 1
• lock washer
• clutch boss nut 2
2. Tighten:
• clutch boss nut
105 Nm (10.5 m · kg, 76 ft · lb)
NOTE:
_
While holding the clutch boss with the univer-
sal clutch holder 3, tighten the clutch boss
nut.
Universal clutch holder
YM-91042
3. Bend the lock washer tab along a flat side of
the nut.
4. Lubricate:
• friction plates
• clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
5 - 47
ENG
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
New
LOCTITE
MMM
LLL
®