Yamaha YZF-R1P Service Manual page 220

HANDLEBARS
2. Install:
• right handlebar switch 1
NOTE:
_
Align the projection a on the right handlebar
switch with the hole b in the right handlebar.
3. Install:
• brake master cylinder holder 1
CAUTION:
_
• Install the brake master cylinder holder
with the "UP" mark facing up.
• First, tighten the upper bolt, then the
lower bolt.
NOTE:
_
• Align the mating surfaces of the brake mas-
ter cylinder holder with the punch mark a in
the right handlebar.
• There should be 2 mm of clearance between
the right handlebar switch and the brake
master cylinder holder.
4. Install:
• throttle grip
• throttle cable housing 1
• throttle cables
NOTE:
_
Align the projection a on the throttle cable
housing with the hole b in the right handlebar.
5. Install:
• clutch lever holder 1
NOTE:
@
Align the slit in the clutch lever holder with the
punch mark a in the left handlebar.
4 - 59
CHAS