Fault code No.
13
Used diagnostic code No. 03 (intake air pressure sensor)
Inspection operation item and probable cause Operation item and countermeasure
Defective intake air pressure sensor
Open or short circuit in wiring harness and/or
sub lead.
Connected state of connector
Inspect the coupler for any pins that may
have pulled out.
Check the locking condition of the coupler.
FUEL INJECTION SYSTEM
Symptom
Intake air pressure sensor - open or short circuit detected.
Replace if defective.
1. Connect the pocket tester (DC 20 V) to the
intake air pressure sensor coupler terminal
as shown.
Tester positive probe → pink/white 1
Tester negative probe → black/blue 2
2. Set the main switch to "ON".
3. Measure the intake air pressure sensor
output voltage.
4. Is the intake air pressure sensor OK?
Repair or replace if there is an open or short
circuit.
Between sensor coupler and ECU coupler
Black/Blue - Black/Blue
Pink/White - Pink/White
Blue - Blue
If there is a malfunction, repair it and connect it
securely.
Intake air pressure sensor coupler
Main wiring harness ECU coupler
Sub-wire harness coupler
7 - 14
2
1
Intake air pressure sensor out-
put voltage
3.75 ~ 4.25 V
FI
Reinstatement
method
Reinstated by turn-
ing the main switch
ON.