Yamaha YZF-R1P Service Manual page 311

CONNECTING RODS AND PISTONS
5 - 75
e. Tighten the nut further to reach the speci-
fied angle (120°).
WARNING
When the nut is tightened more than the
specified angle, do not loosen the nut and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
CAUTION:
• Do not use a torque wrench to tighten the
nut to the specified angle.
• Tighten the nut until it is at the specified
angles.
NOTE:
When using a hexagonal nut, note that the
angle from one corner to another is 60°.
L LLL L LLL L L LLL L L LLL L
ENG
L LLL L L LLL L LLL