Yamaha YZF-R1P Service Manual page 215

FRONT FORK
d. Press down on the spacer with the fork
spring compressor 1.
e. Pull up the rod puller and install the rod
holder 2 between the nut 3 and the
spacer 4.
NOTE:
_
Use the side of the rod holder that is marked
"B".
Fork spring compressor
YM-01441
Rod holder
YM-01434
f. Remove the rod puller and adapter.
g. Install the nut 1 and position it as specified
b.
Distance b
11 mm (0.43 in)
h. Set the cap bolt distance c to specification.
Distance c
13 mm (0.51 in)
i. Install the damper adjusting rod and cap
bolt, and then finger tighten the cap bolt.
j. Hold the cap bolt and tighten the nut to
specification.
Nut
15 Nm (1.5 m · kg, 11 ft · lb)
k. Remove the rod holder and fork spring com-
pressor.
WARNING
@
• The fork spring is compressed.
• Always use a new cap bolt O-ring.
L LLL L LLL L L LLL L
4 - 54
CHAS
L LLL L L LLL L L LLL L LLL