Yamaha YZF-R1P Service Manual page 88

Ú Route under the wire harness
to the assembling point !.
Û Insert the holding clamp of the
wire harness to the frame.
Ü Fasten the wire harness with
the clamp inserted to the
frame.
Ý Route the radiator fan motor
lead above the wire harness.
Þ Assembling point #
Beneath the under bracket
ß Route the handlebar switch
lead and main switch leads
along the groove of the guide-
air.
À To cord headlight
CABLE ROUTING
Á Route the starter motor lead
through the clamp inserted to
the box battery.
Route the starter motor lead
A A
through the clamp inserted to
the box battery.
Clamp the lead as being in
A B
parallel along the fender.
Make sure to clamp three
leads.
Fasten the wire harness with
A C
the clamp inserted to the
hole of the box battery.
Routing position of each lead
A D
except the wire harness is
not regulated in the clamp.
2 - 38
SPEC
Branch from the main har-
A E
ness
Assembling point $
A F
Beneath the under bracket,
below the cover steering
Throttle cable should not be
A G
placed on the rib of guide-air.
To coolant temperature sen-
A H
sor
Do not pinch the handlebar
A I
switch lead when assem-
bling the ignition coil plate.
Pass the filter of throttle body
A J
through the notch of the rub-
ber baffle and release it
under the ignition coil plate.