Weighing; Taring; Pretare - Function - KERN CME 100-3 Operating Instruction

7.3 Weighing

Turn on balance by pressing the ON/OFF key. The balance shows for approx. 3
seconds „88888" in the display and then goes to „0". Now it is ready for
operation.
Important: Should the display flash or not be on „0", press the TARE
button.
Only now (!) place goods onto weighing plate. Take care that the weighed
material does not touch the balance housing or the base mat.
Now the weight is displayed, after the standstill control appears the weighing unit
(e.g. g or kg) right-hand in the display.
If the material to be weighed is heavier than the weighing range, the display will show
"Error" (=Overload).

7.4 Taring

Switch-on the balance using the ON/OFF key and wait for the „0" display.
Place the tare vessel on the weighing plate and press the TARE button. The
balance display goes to „0". The weight of the container is now internally saved.
If after finishing the weighing process the TARE button is pressed again, „0"
appears anew in the display.
The taring process can be repeated any number of times, e.g. when adding several
components for a mixture (adding).
The limit is reached when the whole weighing range is exhausted.
After removing the taring container the total weight is displayed as negative display.

7.5 PRETARE - Function

Using this function the weight of a tare vessel can be stored.
This value also remains saved if the balance meanwhile has been switched off and
switched on again.
1. In weighing mode, place the taring vessel on the weighing platform, keep pressing
the ON/OFF- and TARE-key until the display is extinguished.
2. Let go of both keys, "PRETARE" will pop up briefly on the display. The current
weight on the weighing platform is now being stored as PRETARE weight. The
balance returns automatically into weighing mode.
After removing the taring container the total weight is displayed as negative display. If
required, put the weighing scale display back to zero by pressing the TARE-key.
To delete the tare value in the memory, follow step 1 and 2 without the use of a taring
vessel.
16 CDE/CME/CDEE-BA-e-1014