MAINTENANCE WORK ON CHASSIS AND ENGINE
Changing ignition curve
8.86
–
Dismount the fuel tank. (
Changing the ignition curve from Performance to Soft.
–
Open plug connection
. (Figure 400211-10
A
Soft - better handling (
Change the ignition curve from Performance to Soft.
–
Close plug connection
. (Figure 400278-10
B
Performance - higher performance (
–
Install the fuel tank. (
54)
Removing the seat
8.87
Mounting the seat
8.88
Dismounting the fuel tank
8.89
–
Plug connection open
400278-10
53)
52)
52)
52)
52)
–
Remove screw
above.
500080-10
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Hook in the seat at the front at the flange adaptor from the fuel tank, lower to the
rear and simultaneously push forwards.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Rules
Remaining screws, chas-
sis
500068-01
x
–
Remove the seat (
. Lift up the seat at the rear, pull it back and then remove from
1
M6
53)
53
10 Nm (7.38 lbf ft)