MAINTENANCE WORK ON CHASSIS AND ENGINE
Removing the lower triple clamp
8.30
Installing the lower triple clamp
8.31
3
0 0 3
2
0 0 2
1
0 0 1
x
–
Remove the fork legs. (
–
Dismount the start number plate (
–
Dismount the front fender (
–
Remove screws
Info
Do not unplug the CDI control unit.
–
Remove screw
and place it on one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
500099-10
–
Remove o-ring
–
Remove the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
500100-10
x
–
Clean the bearing and sealing elements, check for damage, and grease.
Long-life grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
Info
Check whether the top steering head seal
–
Push up protective ring
500098-10
–
Position the upper triple clamp with the steering.
–
Mount and tighten screw
Rules
Screw, top steering head
–
Position the clutch line, wiring harness and CDI control unit. Mount and tighten
screws
.
5
Rules
Remaining screws, chas-
sis
500099-11
–
Install front fender. (
–
Fit the start number plate. (
–
Install the fork legs. (
28)
31)
31)
and hang the CDI control unit to the side.
1
. Remove screw
, take off top triple clamp with the handlebar
2
3
. Remove protector ring
.
4
5
84)
and o-ring
.
2
3
.
4
M20x1,5
M6
31)
32)
29)
is correctly positioned.
1
10 Nm (7.38 lbf ft)
10 Nm (7.38 lbf ft)
30