Sony PXW-X500 Operation Manual page 142

Assignable Switch
setting
Zoom Wide/Tele
Focus Magnifier
Zebra
Lens RET
Return Video
Return Video2
Return Video3
Return Video4
Shot Mark1
Shot Mark2
OK Mark
Clip Flag OK
Clip Flag NG
Clip Flag Keep
Electrical CC
CC5600K
Clip Continuous Rec
Function
When a lens that supports serial communication is
installed, assign the Zoom Wide function to
ASSIGNABLE 4, and assign the Zoom Tele function to
ASSIGNABLE 5 (displayed only when <4> and <5> are
set).
Turn the focus magnification function on/off.
Turn zebra display on/off.
Display the return video signal.
When a camera extension unit is not connected, function
as follows.
Rec Review (if playback is allowed)
Display the return 1 video signal.
Display the return 2 video signal.
Display the return 3 video signal.
Display the return 4 video signal.
Write Shot Mark1.
Write Shot Mark2.
Add or delete an OK mark.
Add/Clear an OK mark to/from the clip being recorded
or played.
Add/Clear an NG mark to/from the clip being recorded
or played.
Add/Clear a KP (Keep) mark to/from the clip being
recorded or played.
Function that switches the electrical CC filter (3200K/
4300K/5600K/6300K) applied to white balance
adjustment values.
Each press of the switch or button switches in the order
3200Kt4300Kt5600Kt6300K.
These can also be applied from a menu (apply with
Electrical CC<A><B><C><D>).
Note
This function is not available when Maintenance >White
Filter >ND Filter C.Temp in the setup menu is set to On.
If you set ND Filter C.Temp to On after assigning the
function, the assignable switch ceases to function.
Apply a 5600K electrical CC filter to white balance
adjustment values.
Turn the Clip Continuous Rec mode on/off.
142
State when camcorder
is next powered on
—
Setting not retained
Setting not retained
—
—
—
—
—
—
—
—
Setting not retained
Setting not retained
Setting not retained
Setting retained
Setting retained
Setting not retained