Crease/Center Staple; Default Screen - Konica Minolta bizhub 200 User Manual

Utility mode

Crease/Center Staple

Tab Parameter
5/6 Crease/
Center Staple
Note
The "Crease/Center Staple" parameter appears only if optional finisher or
saddle stitcher is installed.

Default Screen

Tab Parameter
6/6 Default
Screen
Note
The names of parameters and settings may be different when fax kit is
installed.
!
Detail
The Default LCD Screen setting specifies the default screen when the au-
tomatic panel reset operation is performed or the machine is turned off,
then on again.
In order to check the setting after it has been changed, turn the machine
off with the main power switch, and then wait about 10 seconds before
turning it on again. The machine may not operate correctly if it is turned
on immediately after being turned off. For details on turning the machine
off and on, refer to "Turning on the main power and the auxiliary power"
on page 2-22.
200/250/350
Description
Specify the crease and center staple po-
sition for each paper size.
Select a paper size to be set, and then
touch [Enter].
• Crease:
Specify the position of the fold (be-
tween -10 and +10).
• Center Staple:
Specify the position of the center sta-
ple (between -10 and +10).
Description
Default Select one of the following as the
LCD mode screen given priority.
Screen Copy, E-Mail, Scanner
Default E- Select one of the following as the
mail Fax mode screen given priority.
Screen One-Touch, Search, Address In-
put, Index
11
Default setting
Crease: 0
Center Staple: 0
Default setting
Copy
One-Touch
11-17