Purging Brake Line - E-TON ROVER Owner's Manual

Caution: DO NOT Allow dirt to fall into the
reservoir
Refold the cover gasket as shown in picture
and
replace cover.
Purging Brake Lines
Bleecler Valve
THE FRONT CALIPER
THE REAR CALIPER
Copyright ©2008-2009 ETON America, all rights reserved.
Fill to 1/8"
from top
Bleecler Valve
Page 19
For the hydraulic brake system to operate
safely, the brake system must be purged
of air in the lines and reservoir.
To bleed the air will require two people to
perform the following procedure.
1. Place a drain pan under the brake caliper
to catch the fluid.
2. Open the bleeder valve
clockwise.
3. Squeeze the brake lever to expel air
from the system.
4. While holding the brake lever, close the
bleeder valve.
5. Repeat steps 2 through 4 until the brake
fluid coming from the bleeder valve is a
solid stream without any air, then close
the valve and replace rubber protection
cap.
6. Test the brake system by squeezing the
lever, the lever should feel firm and stop
without fading.
Purging Brake Adjustment
As you found out the parking brake which
has been decreased its brake ability, You
must adjus the parking brake, Turn the
adjustment nut of the parking brake to
adjust Parking Brake.
1 /
turn counter
2