Fuel System; Fuel Tank; Fuel Valve - E-TON ROVER Owner's Manual

Fuel System

Fuel Tank

The fuel tank fill cap is located on top of the
back of the seat.
The cap contains a vent to prevent a vacuum
from forming in the tank as fuel is used.
The vent tube must be attached to the cap
and Inserted in the vent tube holder hole
while operating the unit.
The fuel cap vent and vent tube must be
clean and clear of obstructions for the unit to
operate normally. You can check the vent and
vent tube by blowing air through the tube. If
you can not blow through the vent tube and
cap you must clean the vent and tube or
replace them.
Every time you refuel your unit, check the
rubber seal inside the cap for cuts, tears and
dirt. Clean or replace the seal if it becomes
warn or torn. the seal must be in good
condition to insure a proper seal of the cap to
the tank to prevent fuel spills. DO NOT allow
dirt or other debris to enter the tank when
refueling.
Replace the cap if damaged or if it will not
seal to the tank.
Tighten the cap snugly, being careful not to
Copyright ©2008-2009 ETON America, all rights reserved.
CONTROL FEATURE CONTROL FEATURE
ROVER ROVER
ROVER ROVER
GT GT
over tighten. Over tightening the cap can
cause damage to the cap or seal.
The fuel tank capacity is 11 liters, 2.9gal,
including a reserve of 2 liters, 0.5gal.
Use regular unleaded automobile gasoline
with an octane level of 91 or higher.
NEVER REFUEL YOUR vehicle when the
engine is HOT. Wait 30 minutes after turning
off the unit before refueling. Spilling fuel on
a HOT engine could cause a fire. Wipe up
any fuel spills before re-starting.

Fuel Valve

The unit is equipped with a three way fuel
valve located on the left side of the unit just
below the seat.
The valve has three settings; "OFF", "ON"
and "RES". With the valve in the "OFF" position
fuel is held in the tank and is prevented from
flowing to the carburetor. The valve should be
placed in the "OFF" position whenever the
unit is not being operated. Place the valve in
the "ON" for normal operation of the unit.
This allows fuel to flow to the carburetor for
normal operating. The "RES" position allows
fuel to flow from the small reserve in the tank
to allow the unit to be taken to a refueling
location.
When you have to switch to the "RES" position
you must refuel the unit as soon as possible.
ALWA YS CHECK YOUR Fuel level before
you start riding your vehicle. Remember:
You can drive further in one hour on your
Vehicle than you can walk in one day.
Page 11