Step 3 Remove Toekick; Step 4 Install Power Cord - GE Built-In Dishwasher Installation Instructions Manual

Installation Instructions

STEP 3 REMOVE TOEKICK

• Remove the
2 toekick screws
and toekick.
Set aside for use
in Step 18.
Figure I

STEP 4 INSTALL POWER CORD

Skip this step if dishwasher will be direct wired or
has a factory installed power cord.
Use Power Cord Kit WX09X70910, available for
purchase from an authorized GE Appliance Dealer.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
• Maximum power cord
length is 6 feet.
A C
Remove
Insert Power
Junction Box
Cord Wires Thru
Cover
Strain Relief
and Tighten
Ground
B
Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
Figure J
• Connect incoming power cord white (or ribbed) to dishwasher
white, black (or smooth) to black and ground to dishwasher
green wire. Use UL listed wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not pinched
under the cover.
212Dia25
STEP 5 INSTALL 90°
ELBOW
• Wrap 90° elbow with
thread seal tape.
• Install a 90° elbow onto
the water valve.
• Do not over tighten
90° elbow. Water
valve bracket could
bend or water valve
fitting could break.
• Position the end of the
elbow to face the rear
of the dishwasher.
6
Remove 2
Toekick Screws
923-02P
White
D
Use UL Listed
Wire Nuts
Front of Dishwasher
Water Valve
90
Elbow
Fill
Hose
Thread Seal Tape
Figure K
923-02Q
STEP 5A INSTALL DRAIN HOSE TO
Skip this step if drain hose has been pre-installed.
In this step you will need the drain hose set aside prior
to Step 1.
• Stand dishwasher upright.
• Remove hose clamp attached to drain hose. Place hose
clamp over the small end of the drain hose.
Tip: Prevent drain hose damage and possible leaks.
Be careful not to nick or cut the drain hose.
• Push the small end of the drain hose over the drain port of
the dishwasher, see Figure L.
• Make sure hose is fully seated on the dishwasher drain port.
• Position hose clamp against the front lip of the drain hose
and tighten clamp.
Black
Figure L Figure L Figure L Figure L Figure L Figure L Figure L Figure L Figure L Figure L
Hint: for leak free connections:
• Insert hose against stop on pump.
• Position clamp against front lip of drain hose.
• Tighten clamp to at least 15 inch-pounds of torque.
Bracket
Figure M
DISHWASHER DRAIN PORT
Drain Outlet
Flapper Valve
Hose Clamp
Do Not Remove
923-41A
Stop
Stop
Front Lip
of Hose
Shoulder Stop