GE Built-In Dishwasher Installation Instructions Manual

Ge built-in dishwasher installation instructions
Hide thumbs Also See for Built-In Dishwasher:

Advertisement

GE Consumer & Industrial
Appliances

Installation Instructions

Built-In Dishwasher
If you have questions, call 800.GE.CARES (800.432.2737) or visit our website at: www.ge.com

BEFORE YOU BEGIN

Read these instructions completely and
carefully.
IMPORTANT
– Observe all governing codes and
Stop Sign
ordinances.
• Note to Installer – Be sure to leave these instructions for the
consumer's and local inspector's use.
• Note to Consumer – Keep these instructions with your
Owner's Manual for future reference.
• Skill Level – Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills. Proper
installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliance Warranty. See warranty information.
• Completion Time – 1 to 3 Hours. New installations require
more time than replacement installations.
GLD6500LWW/CC/BB
�������������������
IMPORTANT
be installed to allow for future removal from the enclosure
if service is required.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owner's Manual for available
custom panel kits.

FOR YOUR SAFETY

Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While performing
installations described in this booklet, gloves, safety glasses
or goggles should be worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
– The dishwasher MUST

Advertisement

Table of Contents
loading

Summary of Contents for GE Built-In Dishwasher

  • Page 1: Installation Instructions

    GE Consumer & Industrial Appliances Installation Instructions Built-In Dishwasher If you have questions, call 800.GE.CARES (800.432.2737) or visit our website at: www.ge.com BEFORE YOU BEGIN IMPORTANT – The dishwasher MUST be installed to allow for future removal from the enclosure Read these instructions completely and if service is required.
  • Page 2: Installation Preparation

    Installation Preparation PARTS SUPPLIED: Side and Top Trim Pieces on some models ® Two #8-18 x 5/8" Phillips special head screws, to secure dishwasher to underside of countertop or to side of cabinets. (In user bag.) Clamp Drain Hose ® Side and top trim pieces on some models ®...
  • Page 3: Drain Requirements

    Installation Preparation PREPARE DISHWASHER ENCLOSURE WARNING: To reduce the risk of electric shock, fi re, or injury to persons, the installer must ensure that the dishwasher is 625Dia30 completely enclosed at the time of installation. This Wall Area • The dishwasher must be installed so that drain hose is no must be Free more than 10' in length for proper drainage.
  • Page 4: Prepare Electrical Wiring

    Installation Preparation PREPARE ELECTRICAL WIRING Alternate WARNING FOR PERSONAL SAFETY: Remove house Receptacle Location fuse or open circuit breaker before beginning installation. Do not use an 18" extension cord or adapter plug with this 1-1/2" Dia. Hole (Max.) Receptacle appliance. Location 18"...
  • Page 5: Prepare Hot Water Line

    Installation Preparation PREPARE HOT WATER LINE STEP 1 CHECK DOOR BALANCE • The line may enter from either side, rear or floor within the • With dishwasher on the wood skid, check the door balance shaded area shown in Figure F. by opening and closing the door.
  • Page 6: Step 3 Remove Toekick

    Use Power Cord Kit WX09X70910, available for • Make sure hose is fully seated on the dishwasher drain port. purchase from an authorized GE Appliance Dealer. • Position hose clamp against the front lip of the drain hose The power cord and connections must comply with and tighten clamp.
  • Page 7: Step 6 Position Water Line And House Wiring

    Installation Instructions STEP 6 POSITION WATER LINE STEP 8 SLIDE DISHWASHER PARTIALLY AND HOUSE WIRING INTO CABINET • Position water supply line and house wiring on the floor of the DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. opening to avoid interference with base of dishwasher and DAMAGE WILL OCCUR.
  • Page 8: Step 10 Push Dishwasher Into Final Position

    Installation Instructions STEP 10 PUSH DISHWASHER INTO STEP 11 LEVEL DISHWASHER FINAL POSITION IMPORTANT – Dishwasher must be level Tip: Check tub insulation blanket, if equipped. It should be for proper dish rack operation and wash performance. positioned so it is not “bunched up” or interfering with door springs.
  • Page 9: Step 13 Connect Water Supply

    The dishwasher must be secured to the countertop or • Slide ferrule against elbow and secure with compression nut. the cabinet sides. For dishwashers which require side mounting IMPORTANT brackets, order part GPF65 from your authorized GE Appliance – Check to be sure that door Dealer.
  • Page 10: Step 14 Connect Drain Line

    Installation Instructions STEP 14 CONNECT DRAIN LINE DRAIN LINE INSTALLATION • Connect drain line to air gap, waste tee or disposer FOLLOW ALL LOCAL CODES AND ORDINANCES. using either previously determined method. Identify the type of drain hose you have. The molded Method 1 –...
  • Page 11: Step 15 Connect Power Supply

    Installation Instructions STEP 15 CONNECT POWER SUPPLY STEP 16 PRE-TEST CHECK LIST Review this list after installing your dishwasher to avoid If a power cord with plug is used, proceed to Step 16. charges for a service call that is not covered by your •...
  • Page 12: Step 17 Dishwasher Wet Test

    • Be sure to leave complete literature package and correct if required. Installation Instructions with the consumer. SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE GE Consumer & Industrial General Electric Company © 2005 General Electric Company Louisville, Kentucky 40225 Pub. No. 31-30590 Dwg.

Table of Contents