Step 2 Adjust Leveling Legs; Step 3 Remove Toekick; Step 4 Install Power Cord; Step 5 Install 90° Elbow - GE Monogram ZBD1800G Installation Instructions Manual

STEP 2 ADJUST LEVELING LEGS

• Move the dishwasher close to the installation
location and lay it on its back.
Adjust to
Installation
Height
Figure L
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4" less than installation height.

STEP 3 REMOVE TOEKICK

• Remove the 4 toekick screws. Lift off the 2-piece
toekick.
Remove
4 Toekick
Screws
Figure M
Installation Instructions

STEP 4 INSTALL POWER CORD

Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
• Recommended power cord length is 54" min. and
64" max.
A
Remove
Junction Box
Cover
D
Use UL Listed
Wire Nuts
Figure N
• Connect incoming power cord white (or ribbed)
to dishwasher white, black (or smooth) to black and
ground to dishwasher green wire. Use UL listed wire
nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 5 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
90°
Elbow
Figure O
• Do not over tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
9
B Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Hole in Back
White
Ground
Black
C
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Fill
Hose
Water
Valve
Bracket
Thread
Seal Tape